If the problem is still present, remove the wire from the fuse box and place it on the same terminal as the green wire from the key switch. Sometimes the prongs that hold the fuse can become loose and need to be squeezed together to hold the fuse more securely. Check that the connection is free of any corrosion. If it checks ok at the plug, locate the same wire at the fuse box and check that it is tight there. That wire should be either white or grey. If this is happening, check the wire in the pin 1 location of the 12 pin controller plug on the wiring harness side. When the controller powered back up, it saw the direction switch engaged at power up and therefore produced a 2 flash fault. If a buggy starts off operating normal and then produces a 2 flash code during operation, typically it is because the controller has lost and then regained power. This is usually caused when either the directional switch on the dash is in forward or reverse when the key is switched on, or if the accelerator is depressed before the key is turned on. The service department at Bad Boy Buggies for further assistance.Ģ Flash. If the controller does not respond to reprogramming, please contact This code can appear on one or both controllers at the same time. Updating the controller software should solve this problem. The only way to correct this is to reprogram the controller with the newest software version utilizing the PcPak. This is caused by one of the settings in the controller being set out of permissible range.
PARCAR SEVCON MILLIPAK CODES MANUAL
This is what the manual says about fault codes.ġ Flash.
PARCAR SEVCON MILLIPAK CODES MANUALS
I've got some Bad Boy Classic Buggies manuals here.
0 kommentar(er)
